Avaya g700 Installation And Upgrades page 529

Show System List for G700 Media Gateway
3. Write the serial number on your planning document.
Make sure it matches the serial number sticker on the back of the G700 Media Gateway
chassis. If there is a difference, the serial number in the displayed list is correct.You will
need this later.
After you have assigned an IP address to the G700 processor, telnet directly to the G700 media
gateway processor and login (the login name and password are provided in the planning
documentation).
To assign the IP address to the G700 media gateway processor
1. At the MG-???-n(super)# prompt, type configure to change to configuration mode.
2. Type nvram init to recondition the processor.
This command ensures that any existing configuration information is cleared so you can
enter the IP address and IP route information.
The system prompts you to verify that you want to erase the configuration.
Configure the G700
Issue 8.1 June 2005 529