Manual installation of a new G700 with an S8300
Administering IP Interfaces
This procedure assigns network region 1, as an example, to the S8300 media server.
To assign the network region to the S8300
1. At the SAT prompt, type change ip-interfaces procr.
The S8300 displays the IP Interfaces screen for the media server.
IP Interfaces Screen
change ip-interfaces procr
Enable Ehternet Port?
2. The field Enable Ethernet Port? should indicate y (yes). The Node Name should be the IP
address of the S8300 media server.
Administering the LSP Form
If the primary controller has LSPs, you must enter the LSP node names on the LSP form to
enable the LSPs to get translations updates from the primary controller. Once the LSPs are
successfully entered on the LSP screen, their status can be viewed with the display lsp
command.
Note:
The LSP node names must be administered on the node-names-ip form before
Note:
they can be entered on the LSP screen.
To add LSP names to the LSP screen
1. At the S8300 SAT prompt, type change lsp to open the LSP screen.
498 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
Type: PROCR
Node Name: procr
IP Address: 135.9.41.146
Subnet Mask: 255.255.255.0
Nework Region: 1
IP INTERFACES
Page
1 of 1