Upgrading The S8300A - Avaya g700 Installation And Upgrades

The best way to record the configuration data is to fill in the Electronic Pre-installation
Worksheet (EPW). You then have the option to use the Installation Wizard to do the server
configuration task. If you do not have the EPW, you can record the current configuration data
and enter it manually after the upgrade.
7. If upgrading from 1.2 or later, record the data displayed on the Configure Interface screen:
- Server IP address
- Gateway IP address,
- Subnet mask
You can skip the remaining configuration screens.
8. If upgrading from pre-1.2 release, record the data from all configuration screens.

Upgrading the S8300A

!
CAUTION:
This upgrade procedure, including remastering the hard drive on the S8300,
CAUTION:
requires a service interruption of approximately 4 hours, or up to 6 hours if IA770
is being used.
This section describes the procedures for upgrading the S8300A Media Server from a pre-3.0
release of Communication manager to release 3.0.
Upgrading an S8300 to release 3.0 requires removing the S8300A and replacing it with an
S8300B. The new S8300B should have the remastering program (RP) software installed on its
hard drive. The remastering program remasters the hard drive and installs the R 3.0
Communications Manager software. These procedures are described in this section.
This section covers:
Installing the pre-upgrade software service pack, if necessary
●
Linux migration backup (if current release is 1.2.0 through 1.3.x)
●
Replacing the S8300A with the S8300B Media Server
●
Upgrading Communication Manager software
●
on page 238
on page 240
on page 243
on page 244
Issue 8.1 June 2005
Upgrading the S8300A
237