Setting Rapid Spanning Tree On The Network - Avaya g700 Installation And Upgrades

6. In the TYPE column, find the particular media module (v1 through v4), then check the
matching field in the FW VINTAGE column to see if it matches the planning documentation.
Note:
Slot V1 can contain either a media module or the S8300, which will show as
Note:
TYPE ICC.
7. Check the VOIP FW column and row for slot v0 to see if the number matches the VoIP
firmware identified in the planning documentation.
8. Type reset <module #>
where <module #> is the number of the G700 in the stack.
9. When the reset is finished, type show mm to verify the upgrade.
To release board (if media module was busied out)
1. When the upgrade procedure is complete, go to the SAT session and release the board
Type release board vx
where x is the slot number of the upgraded media module.
2. Verify the response,
Command Successfully Completed
Note:
If you see the response, Board Not Inserted, this means that the media
Note:
module is still rebooting. Wait one minute and repeat the release board
command.
3. Repeat the release board command for each media module that was busied out.

Setting rapid spanning tree on the network

Spanning Tree (STP) is a loop avoidance protocol. If you don't have loops in your network, you
don't need STP. The "safe" option is always to leave STP enabled. Failure to do so on a network
with a loop (or a network where someone inadvertently plugs the wrong cable into the wrong
ports) will lead to a complete cessation of all traffic. Rapid Spanning Tree is a fast-converging
protocol, faster than the earlier STP, that enables new ports much faster (sub-second) than the
older protocol. Rapid Spanning Tree works with all Avaya equipment, and can be
recommended.
Rapid Spanning Tree is set using the P330 stack processor command line interface.
Install New Firmware on the G700 Media Gateway
Issue 8.1 June 2005 543