Avaya g700 Installation And Upgrades page 207

5. If specifically requested by the customer or your planning documents, type
gateway-announcements in the V9 field.
This field allows you to enable announcements on the G700 media gateway. V9 is a virtual
slot. There is no announcement board associated with it. The announcements for the G700
are available in the G700 firmware and are administered in the same way as
announcements on the TN2301 circuit pack used on S8500 or S8700 port networks.
If there are multiple G700 media gateways sharing announcements, then enable
announcements on the G700 whose trunks will receive the announcements most often.
6. Press F3 (Enter) to save your changes.
If properly administered, the G700 should register with the primary controller within 1–2
minutes. The IP Address, MAC Address, and Module Type fields are populated
automatically after the G700 media gateway registers with the server.
7. Type change media-gateway to view the Media Gateway screen.
Media Gateway screen (after registration with primary controller)
change media-gateway 1
Number: 1
Type: g700
Name: Swainsons
Serial No: 012X06230551
Network Region: 1
Registered? y
Slot Module Type
V1: S8300
V2: MM712
V3: MM711
V4: MM710
V8:
V9:
The media modules installed in the G700 are listed next to their slot numbers. Verify that a
G700 media gateway has been successfully added.
To verify changes
1. At the SAT prompt, type list media-gateway.
MEDIA GATEWAY
IP Address: 135.9.41.150
FW Version/HW Vintage: 21.13.0 /0
MAC Address: 00:04:0d:02:06:ca
Encrypt Link? y
Location: 1
Controller IP Address: 135.9.41.146
Site Data:
Name
ICC MM
DCP MM
ANA MM
T1/E1 MM
Administer Communication Manager
Page 1 of 1
Issue 8.1 June 2005 207