Getting Ia770 (Audix) Data And Stopping Ia770; (If Ia770 Is Being Used); Determining Whether Optional Languages Are Needed - Avaya g700 Installation And Upgrades

Upgrade of an existing S8300B to R3.0 with manual upgrade of G700 firmware
1. Logoff the SAT session.
2. At the command prompt, type almenable -d n -s n, where
-d n sets the dialout option to neither (number)
-s n disables SNMP alarm origination
Note:
Be sure to reset alarm origination after the upgrade.
Note:
3. Type almenable (without any options) to verify the alarm origination status.
You should see:
incoming: enable
Dial Out Alarm Origination: neither
SNMP Alarm Origination: n

Getting IA770 (AUDIX) Data and Stopping IA770

(if IA770 is being used)

Skip to Backing up S8300 recovery system files
If IA770 is being used, you need to collect optional language data (if this had not been done
before arriving at the site), leave a test message, and shut down IA770 before backing up the
files.

Determining whether optional languages are needed

To determine the system language
1. On the Maintenance Web Interface, under Miscellaneous select Messaging
Administration.
2. Select Global Administration; then Messaging Administration.
3. Enter the craft password.
4. At the command prompt, enter display system-parameters features.
The SYSTEM PARAMETERS FEATURES screen displays.
5. Go to page 3.
652 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
on page 656 if IA770 is not being used.