Assigning Node Names And Ip Addresses For The Lsps - Avaya g700 Installation And Upgrades

In this section, you will use the SAT interface to:

Assigning Node Names and IP Addresses for the LSPs

●
Administering Network Regions
●
Associating LSPs with Network Regions
●
Administering IP Interfaces
●
Administering the LSP Form
●
!
CAUTION:
Before continuing, be sure you have saved translations in Communication
CAUTION:
Manager.
Begin by resetting the system.
To reset the System
1. Telnet to the S8300, log in, and open a SAT session (type sat or dsat).
2. At the SAT prompt, type reset system 4
The system reboots.
3. After the reboot is complete, telnet to the S8300, login, and open a SAT session.
Assigning Node Names and IP Addresses for the LSPs
If the S8300 network configuration includes LSPs, they must be specified on the Node Names
screen.
To assign node names
1. At the S8300 SAT prompt, type change node-names ip to open the Node Names
screen.
Example Node Names Screen
change node-names ip
Name
default_________
node-10-lsp
node-11-lsp
__________
__________
__________
2. Enter the name and IP addresses for the LSPs.
3. Press F3 (Enter) when complete.
IP NODE NAMES
IP Address
0__.0__.0__.0__ _______________
192.168.1 _.50_ _______________
192.168.1 _.51_ _______________
___.___.___. _ _______________
___.___.___. _ _______________
___.___.___. _ _______________
Administer Communication Manager
Name
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
Page 1 of 1
IP Address
Issue 8.1 June 2005 161