Assigning Lsps To The Network Regions - Avaya g700 Installation And Upgrades

Installing a new G700 without an S8300
IP Network Region Screen, Page 3
display ip-network-region 1
src dst
rgn rgn
1 1
1 2
1 3
1 4
1 5
1 6
1 7
1 8
1 9
1 10
1 11
1 12
1 13
1 14
1 15
4. Type the number for the type of codec set (1–7) that the S8500 or S8700 will use to
interconnect the G700 and the C-LAN board(s) in the row corresponding to the region of the
C-LAN.
In this example, the C-LAN is in region 9 and codec-set type 3 is to be used for the
interconnection between region 1 and region 9. (In this example, codec type 1 is used for
communication within region 1)
The SAT command, list ip-codec-set, lists the types of codecs available on this server.
For more detail about the Inter Network Region Connection Management form, see
''Administration for Network Connectivity for Avaya Communication Manager,
555-233-504.''
5. Press F3 (Enter) when complete.

Assigning LSPs to the Network Regions

If the primary controller has LSPs, you can assign the LSPs to network regions. In the event of
a network failure, IP telephones assigned to a network region will register with the LSPs
assigned to that region.
This procedure assigns up to six LSPs to a network region.
To assign LSPs to a network region
1. On the IP Network Region screen, go to page 2.
202 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
Inter Network Region Connection Management
codec direct
set WAN WAN-BW-limints
1
3
Page
Intervening-regions
3 of 19
Dynamic CAC
Gateway IGAR