Upgrading an existing G700 without an S8300
On-site preparation for the upgrade
Before installing new firmware on the G700 processors and medial modules you need to
prepare on-site by:
Accessing the P330 Stack Processor
●
Verifying the contents of the tftpboot directory
●
as described in this section.
Accessing the P330 Stack Processor
See
About connection and login methods
and login.
Log on to the P330 Stack Processor using one of the following methods:
Using a LAN connection, telnet to the IP address of the P330 Stack Processor and log in.
●
If you are not using your laptop as the TFTP server, you can connect your Laptop directly
●
to the G700 Console (Serial) Port. Then use HyperTerm or a similar terminal emulation
application to log in to the P330 Stack Processor Command Line Interface (CLI).
You are now logged-in at the Supervisor level with prompt P330-1(super)#.
328 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
on page 328
on page 329
on page 47 for details on how to set up a connection