Complete The Upgrade Process (S8300 Is The Primary Controller) - Avaya g700 Installation And Upgrades

Upgrade of an existing S8300A to R3.0 with manual upgrade of G700 firmware
To download optional language files
1. Insert the optional language CD in your laptop's CD-ROM drive.
2. On the Maintenance Web Interface, under Miscellaneous, select Download Files.
3. Select the "Files to download from the machine I'm using to connect to the server"
download method.
4. Browse to the laptop CD and select each language file that you wish to copy.
5. Click the Download button. When the transfer is complete, the message "Files have been
successfully downloaded to the server" is displayed.
6. If more than four optional language files need to be downloaded, repeat this procedure.
7. To install the language files, under Miscellaneous click Messaging Administration, then
Utilities, then Software Management, then Software Installation. Follow the instructions
to install the language software.
Complete the upgrade process
(S8300 is the primary controller)
Telnet to the S8300 (primary controller) and open a SAT session to complete the following
procedures.
To check media modules
1. Type list configuration all and press Enter.
2. Verify that the software is communicating with all media modules and that all media
modules are listed in the reports.
3. Make test telephone calls to verify that Communication Manager is working.
To enable scheduled maintenance
1. Type change system-parameters maintenance and press Enter.
2. Ensure that the Start Time and Stop Time fields' administration is the same as before the
upgrade.
To busy out trunks
1. Busy out trunks that were busied out before the upgrade (see
S8300 is the primary controller
636 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
on page 578).
Pre-Upgrade Tasks — If the