What Are The Functions Of The S8300 Led Indicators - Avaya g700 Installation And Upgrades

Avaya C360 BUPS back-up power supply module.
●
The Avaya C360 BUPS can support up to four Avaya C360 switches.
One RJ45/RS232 front panel console connector that is used for both terminal and modem
●
sessions.
Three fan units with operation sensors for each switch.
●
One virtual IP address for managing the whole stack that allows the C360 stack to be
●
managed as a single entity.
The ability to hot-swap one switch at a time by activation of the redundant cable:
●
- Does not disrupt the operation of other Avaya C360 switches.
- Does not change stack configuration.
- Does not require network downtime.
Connection through Telnet from the front panel ports of any switch:
●
- Multiple levels of password protection
- Login and inactivity timeouts

What are the functions of the S8300 LED Indicators

A set of LED indicators the faceplate of the S8300 are separate from those of the G700. A
shutdown button is also on the faceplate, which when depressed for about three seconds, will
shut down the system, including the operating software on the S8300. The LED flashes when
shutdown is in progress and remains on steady when it is safe to remove the S8300 or to power
down.
The functions of the S8300 LEDs are:
The red ALM LED on the S8300 is off when the system is operational unless a Major
●
Alarm has been raised.
The green TST LED on the S8300 (primary controller or LSP) is on when Communication
●
Manager is running.
The yellow ACT LED on the S8300 is on whenever a G700, an IP telephone, or an IP
●
console is registered with the S8300. It is off when none of these IP endpoints are
registered.
The green OK-to-Remove LED on the S8300 indicates that shutdown is complete and that
●
it is safe to remove the server or power down the system.
When the S8300 is a local survivable processor (LSP), no LEDs will be lit during normal
operations. In case of a network failure or loss of contact with the primary S8300 (or S8500 or
S8700/S8710), the G700 Media Gateway will register with the LSP. At that time, the red Alarm
LED will light.
About hardware components
Issue 8.1 June 2005 81