Installing New Firmware On The Media Modules - Avaya g700 Installation And Upgrades

Media gateway and media server

Hide thumbs Also See for g700:

Table of Contents

Upgrade of an existing S8300A to R3.0 with manual upgrade of G700 firmware

10. Verify that the download was successful when the prompt returns.

Type show mg list_config.

The system displays the list of software.

Example: Show mg list_config

------ -----

Installing new firmware on the media modules

For upgrades of active media modules, you need to take the media modules out of service

before initiating the upgrade process. To do this, go to a SAT session on the primary controller

and issue a busyout command.

Skip this busyout procedure if the media modules are not in service; for example

during an initial installation.

To busyout board (for active media modules)

1. Go to a SAT session on the primary controller and enter the command,

busyout board vx

where x is the slot number of the media module to be upgraded.

2. Verify the response,

Command Successfully Completed

3. Repeat for each media module to be upgraded.

To install media module firmware

1. Be sure that you have checked for the current vintage of the VoIP Module for the v0 slot (on

the G700 motherboard).

This VoIP module does not occupy a physical position like other media modules.

2. At the P330-1(configure)# prompt, type session mgp.

3. At the MG-001-1(super)# prompt, type configure to change to the configuration mode.

624 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server