Administering The Media Gateway - Avaya g700 Installation And Upgrades

Manual installation of a new G700 with an S8300
Note:
The LSP node names must be administered on the node-names-ip form before
Note:
they can be entered on the LSP form.
To add LSP names to the LSP screen
1. At the SAT prompt, type change lsp to open the LSP screen.
LSP Screen
change lsp
Number NAME
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
2. Enter the node name for each LSP supported by the primary controller.
3. Submit the form.

Administering the Media Gateway

To perform the procedures in this section, telnet to the primary controller, log in, and open a SAT
session.
!
CAUTION:
Before administering a media gateway, make sure that the gateway has been
CAUTION:
fully configured.
506 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
LOCAL SURVIVABLE PROCESSOR
IP Address
node-10-LSP_ 192.168.1.50
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
____________
Page
Service Translations
State? Updated
in-service 14:21 5/4/2003
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
1 of 16