Procedure Two: Restoring Data Backup (If Upgrading From R1.2.X Through 2.X) - Avaya g700 Installation And Upgrades

To configure the server using the Avaya Installation Wizard
If you have upgraded from a pre-1.2 release (Procedure One), you must enter all server
configuration information. You can do this most easily using the Avaya Installation Wizard (IW),
which will do the server configuration and install the license and password files. If you have filled
in the Electronic Pre-installation Worksheet (EPW), the IW will read the configuration data
from the EPW. Otherwise, you will need to enter the configuration data into the IW.
For information on using the Avaya Installation Wizard, see Job Aid: Avaya Installation Wizard,
555-245-754. An interactive demo of the IW can be found at http://support.avaya.com/avayaiw.
Restart the server
You must restart the server to capture the configuration data.
1. Telnet to the S8300 and log on.
2. Type /opt/ws/drestart 1 4.
You will see the response, Killed.
Procedure Two: Restoring data backup
(If upgrading from R1.2.x through 2.x)
Do these tasks:
if the original release was between 1.2.0 and 1.3.9, and you performed a Linux Migration
●
backup
or if the original release was 2.0 or later and you performed a normal data backup
●
To restore backup data:
1. On the Maintenance Web Interface, under Data Backup/Restore select View/Restore Data.
The system displays the View/Restore Data screen.
Upgrading the S8300A
Issue 8.1 June 2005 609