Upgrade of an existing S8300A to R3.0 with manual upgrade of G700 firmware
Restoring data
In this section you will restore the system data that you backed up. Do only one of the following
two procedures, depending on how you backed up the data:
Procedure One: Restoring data backup (if upgrading from a Pre-1.2 release)
●
Procedure Two: Restoring data backup (If upgrading from R1.2.x through 2.x)
●
Note:
The backup and restore processes use the ping service to check connectivity to
Note:
the backup server. If a backup or restore operation fails, ensure that the ping
service is enabled:
a. On the Maintenance Web Interface, under Security, select Firewall.
b. In the Service column, find ping.
c. The checkboxes for both Input to Server and Output from Server should be
checked.
Procedure One: Restoring data backup
(if upgrading from a Pre-1.2 release)
Do these tasks only if you have upgraded from a pre-1.2 release.
To restore translations from a pre-1.2 release:
1. Select View/Restore Data under Data Backup/Restore.
2. Select FTP and enter the information for the FTP backup server.
Click View.
3. Select the Communication Manager translations backup set to restore (filename begins with
"xln".
Click Restore.
!
Important:
Do not restore the system or security backup sets (filenames beginning with "os"
Important:
and "security"). If you backed up the AUDIX data, you will need to restore the
AUDIX backup sets as separate steps. The AUDIX translations, names, and
messages backup set filename begins with "audix-tr-name-msg". The AUDIX
announcement backup set filename begins with "audix-ann".
608 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
on page 608
on page 609