Linux Migration Backup (If Current Release Is 1.2.0 Through 1.3.X) - Avaya g700 Installation And Upgrades

Upgrading an existing S8300A to R3.0 using the Wizards
5. Select the number corresponding to the service pack file. (For example,
00.0.339.4-xxxx.tar.gz). Press Enter.
6. Type update_show and press Enter to list Communication Manager files to verify that the
new service pack file was unpacked.
7. Type update_activate update, where update is the release or issue number of the
latest service pack file. (For example, 00.0.339.4-xxxx. Do not use the .tar.gz extension
at the end of the file name). Press Enter.
The media server may reboot. If it reboots, it also may display the message
/opt/ecs/sbin/drestart 2 4 command failed.
Ignore this message. You must wait until the restart/reset completes before entering
additional commands.
The media server displays a message that the service pack was applied.
8. Type update_show again and press Enter to list Communication Manager files to verify
the service pack file was activated.
9. Enter y in response to the question, Commit this software?
Linux migration backup
(if current release is 1.2.0 through 1.3.x)
!
Important:
Skip to
Important:
current software release is 2.x. If you are upgrading from a 2.x release, the Linux
Migration Backup may not work. After the upgrade, you will restore data from the
system backup you did earlier.
In this section, you will use the Linux Migration Backup procedure on the Maintenance Web
Interface to save the system files and translations. After the upgrade, you will use the View/
Restore Data feature to restore these files.
To perform the Linux migration backup
1. Launch the Maintenance Web Interface. Under Server Configuration click Linux Migration
(Backup/Restore).
The Linux Migration - Backup screen displays.
240 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
Replacing the S8300A with the S8300B Media Server on page 243 if the