Avaya g700 Installation And Upgrades page 330

Upgrading an existing G700 without an S8300
To determine if new firmware for the P330 stack processor is necessary
1. At either the P330-1(super)# or P330-1(configure)# prompt, type dir.
The system displays the directory list of software for the P330 stack processor.
Directory list for P300 stack processor
M# file
-- ----
1 module-config
Configuration
1 stack-config
1 EW_Archive
1 Booter_Image
2. Check the version number (ver num) of the EW_Archive file to see if it matches the Release
Letter.
If not, you must upgrade the P330 stack processor.
3. Type show image version
The system displays the list of software.
Show image version List for P330 stack processor
Mod
------
3
3
4. Check the version number of the stack software image file in Band B to see if it matches the
your planning document.
If not, you must upgrade the P330 stack processor.
To determine if new firmware is required for the MGP, VoIP module, and installed
media modules
1. Type session mgp
2. At the MG-001-1(super)# prompt, type show mg list_config
The system displays the list of software.
330 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
ver num
-------
N/A
N/A
4.0.4
3.2.5
Module-Type
-----------
Avaya G700 media gateway
Avaya G700 media gateway
file type file location
---------- -------------
Running Conf Ram
Running Conf Ram
SW Web Image NV-Ram
SW BootImage NV-Ram
file description
----------------
Module
Stack Configuration
WEB Download
Booter Image
Bank Version
---- -------
A 0.0.0
B 4.0.17