Setting The Lsp Transition Points - Avaya g700 Installation And Upgrades

Manual installation of a new G700 without an S8300
The system ultimately returns you to the P330-1 (configure) prompt.
At the P330-1(configure)# prompt, type session mgp.
At the MG-001-1(super)# prompt, type configure to change to the configuration mode.
Note:
Because the G700 media gateway has registered with its primary controller, the
Note:
prompt name has changed; for example, to MG-001-1.
Type show mgc to display the list of available servers and their IP addresses.
For example:
Show Call Controller Status Screen
MG-001-1(configure)# show mgc
CALL CONTROLLER STATUS
------------------------------------------
Registered
Active Controller
H248 Link Status
H248 Link Error Code: 0x0
MGC List Management : Static
CONFIGURED MGC HOST
--------------------
135.9.71.95
- Not Available --
- Not Available --
- Not Available --
The Gateway will have registered with the primary controller, if present. If the primary
controller is running and has been administered properly, the Registered field says YES
and the H248 Link Status says UP. If the controller is not running, the Registered field says
NO and the H248 Link Status says DOWN.

Setting the LSP Transition Points

You must set the length of time that the G700 searches, in the event of a network problem, for
primary controllers (for example, additional CLAN connections) with which to register. After this
search time has elapsed, the G700 will search for an LSP with which to register. You must also
set the total time the G700 searches for either a primary controller and an LSP, after which the
G700 resets. And finally, you must define how many primary controllers, from 1 to 4, are in the
controller list you just defined.
534 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
: YES
: 135.9.71.95
: UP
DHCP SPECIFIED MGC HOST
-----------------------
-- Not Available --
-- Not Available --
-- Not Available --
-- Not Available --