Upgrading The S8300B Media Server; Setting Telnet Parameters - Avaya g700 Installation And Upgrades

Upgrade of an existing S8300A to R3.0 with manual upgrade of G700 firmware

Upgrading the S8300B Media Server

Setting telnet parameters

●
Remastering the hard drive and installing the upgrade software
●
Verifying software version
●
Copying files to the S8300
●
Configuring network parameters
●
Verifying connectivity
●
Procedure One: Restoring data backup (if upgrading from a Pre-1.2 release)
●
Procedure Two: Restoring data backup (If upgrading from R1.2.x through 2.x)
●
Verifying the time, date, and time zone
●
Verifying media server configuration
●
Installing the new license file
●
Installing the new authentication file, if any
●
Saving translations (if not using IA770 and S8300 is not an LSP)
●
Verifying operation
●
Setting telnet parameters
The Microsoft Telnet application may be set to send a carriage return (CR) and line feed (LF)
each time you press Enter. The installation program sees this as two key presses. You need to
correct this before you Telnet to the server.
Note:
This procedure is done entirely on your laptop, not on the S8300.
Note:
To set telnet parameters
1. Click Start > Run to open the Run dialog box.
2. Type telnet and press Enter to open a Microsoft Telnet session.
3. Type unset crlf and press Enter.
4. Type display and press Enter to confirm that Sending only CR is set.
5. Type quit and press Enter to save the setting and close the window.
This procedure resets your Microsoft Telnet defaults and does not need to be done each time
you use Telnet.
596 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
on page 596
on page 602
on page 603
on page 605
on page 606
on page 613
on page 613
on page 615
on page 617
on page 597
on page 616
on page 608
on page 609
on page 617