On-Site Preparation For The Upgrade; Accessing The S8300 - Avaya g700 Installation And Upgrades

Upgrading an existing S8300B to R3.0 using the Wizards

On-site Preparation for the Upgrade

Perform the following tasks before starting the software upgrade on the S8300:

Accessing the S8300

●
Completing pre-upgrade tasks — If the target S8300 is the primary controller
●
Getting IA770 (AUDIX) Data and Stopping IA770 (if IA770 is being used)
●
Backing up S8300 recovery system files
●
Copying license and authentication files to the S8300 hard drive (from your laptop)
●
page 300
Saving translations (only if new license and/or authentication files installed)
●
Copying the software and firmware files from the Server CD
●
Accessing the S8300
To perform the installation and upgrade procedures you will need to connect your laptop to the
S8300 Services port using a crossover cable. For a direct connection to the S8300 Services
port, your laptop must be properly configured. See
the services port
You will use both telnet and the Maintenance Web Interface to perform the procedures.
To access the S8300 using telnet
1. Click Start > Run to open the Run dialog box.
2. Type telnet 192.11.13.6 and press Enter.
3. Log in as craft or dadmin.
To access the S8300 using the Maintenance Web interface
1. Launch the Web browser.
2. Type 192.11.13.6 in the Address field to open the Logon page.
3. Log on as craft or dadmin when prompted.
4. Click Launch Maintenance Web Interface to get to the Main Menu.
288 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
on page 288
on page 48.
on page 296
on page 302
Laptop configuration for direct connection to
on page 289
on page 292
on
on page 313