Installing New Firmware On The Media Modules - Avaya g700 Installation And Upgrades

For example:
copy tftp mgp-image a mgp_8_0.bin 195.123.49.54
The screen shows the progress.
5. Type set mgp bootimage <bank>
where <bank> is the same letter you entered in the previous step.
6. At the MG-???-1(configure)# prompt, type reset mgp.
A system prompt asks you to confirm the reset.
7. Select Yes at the dialog box that asks if you want to continue.
The G700 media gateway processor resets. The LEDs on the G700 media gateway and the
media modules flash. These elements each conduct a series of self-tests. When the LEDs
on the media modules are extinguished and the active status LEDs on the G700 media
gateway are on, the reset is complete.
8. When the P330-1(super)# prompt appears, type session mgp.
9. At the MGP-???-1(super)# prompt, type configure.
10. Verify that the download was successful when the prompt returns.
Type show mg list_config.
The system displays the list of software.
Example: Show mg list_config
SLOT TYPE
---- ------ -----
V0 G700
V1 ICC
V2 DCP
V3 ANA
V4 DS1

Installing new firmware on the media modules

For upgrades of active media modules, you need to take the media modules out of service
before initiating the upgrade process. To do this, go to a SAT session on the primary controller
and issue a busyout command.
Note:
Skip this busyout procedure if the media modules are not in service; for example
Note:
during an initial installation.
CODE SUFFIX HW VINTAGE
------ ----------
DAF1 A 00
S8300 A 72
MM712 A 2
MM711 A 2
MM710 A 1
Install New Firmware on the G700 Media Gateway
FW VINTAGE VOIP FW
---------- -------
230(A) 67
00 N/A
58 N/A
57 N/A
58 N/A
Issue 8.1 June 2005 541