Setting Telnet Parameters; Remastering The Hard Drive And Installing The Upgrade Software - Avaya g700 Installation And Upgrades

Verifying media server configuration
●
Installing the updated license file
●
Installing the new authentication file, if any
●
Saving translations (if not using IA770 and S8300 is not an LSP)
●
Verifying operation
●

Setting telnet parameters

The Microsoft Telnet application may be set to send a carriage return (CR) and line feed (LF)
each time you press Enter. The installation program sees this as two key presses. You need to
correct this before you Telnet to the server.
Note:
This procedure is done entirely on your laptop, not on the S8300.
Note:
To set telnet parameters
1. Click Start > Run to open the Run dialog box.
2. Type telnet and press Enter to open a Microsoft Telnet session.
3. Type unset crlf and press Enter.
4. Type display and press Enter to confirm that Sending only CR is set.
5. Type quit and press Enter to save the setting and close the window.
This procedure resets your Microsoft Telnet defaults and does not need to be done each time
you use Telnet.

Remastering the hard drive and installing the upgrade software

To do before you start the upgrade
1. Verify that the S8300B is inserted in slot V1.
2. Verify good AC power connections to the G700.
3. Avaya recommends using a UPS backup for media servers.
If a UPS is present, make sure the G700 is plugged into the UPS.
4. Verify that all Ethernet connections are secure, to ensure the file transfer process is not
interrupted.
on page 262
on page 264
on page 266
on page 265
Upgrading the S8300A
on page 266
Issue 8.1 June 2005 245