Table of Contents
Advertisement
For more information refer to:
•
Hard drive LED states
•
RAID controller LED states
•
When the 703t server does not boot and makes audible beeps
•
When the 703t server boots to the operating system and makes audible beeps
page 33
What to do when the server fails to boot into service
The following sections suggest tasks you can perform to determine why the 703t server fails
the bootup cycle.
To investigate server boot problems
1. Ensure that you accurately record any diagnostic codes and error messages that
2. Try restarting the server by pressing the power button on the server.
3. During the boot sequence, view the diagnostic codes on the monitor for failures.
4. If errors indicate a hardware problem with a failure to boot to the operating system or
5. If you still cannot find the cause of the boot failure after performing the tasks
When the 703t server does not boot and there are no audible
beeps
To check why server fans are not turning when server does not boot
1. Ensure that the power cord is properly connected into an electrical outlet.
2. If the problem continues, ensure that there is power to the electrical outlet.
Avaya CallPilot® 703t Server Maintenance and Diagnostics
on page 22
occur.
Note:
Allow 5 minutes for the boot cycle to complete.
if the server boots to the operating system, but fails to boot into CallPilot, refer to
the CallPilot Troubleshooting Guide
described in the following sections, call your Avaya technical support
representative.
What to do when the server fails to boot into service
on page 27
on page 32
on
December 2010
31
Advertisement
Table of Contents
