Avaya g700 Installation And Upgrades page 528

Manual installation of a new G700 without an S8300
6. Login at the Welcome to P330 menu.
The prompt P330-1(super)# appears.
7. Type configure to obtain the P330-1(configure)# prompt.
To establish IP routing for the stack
1. Type show interface inband to verify that the Avaya P330 stack server (Layer 2
Switching Processor) has the correct address.
2. Type set ip route 0.0.0.0 <default-gateway> to specify the gateway to handle
addresses outside of the local subnet.
<default-gateway> is the IP address of the customer's default network gateway. This
address should be available in the planning documentation.
3. Press Enter to save the destination and gateway IP addresses.
4. Type show ip route.
The route net and route host tables appear. Verify that the information is correct.
After you have configured the P330 stack processor, you assign an IP address to the G700
Media Gateway Processor (MGP). Your first task is to check the serial number of the MGP.
To check the serial number of the G700 media gateway processor
1. At the P330-1(configure)# prompt, type session mgp.
2. At the MG-???-1(super)# prompt, type show system to list various attributes of the G700.
The system displays a list of attributes, as shown in the following example:
528 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server