Installing a new G700 with an S8300
Administering an S8500 or S8700 primary controller
In this case, the S8300 you have installed is configured as an LSP.
!
CAUTION:
This administration applies only to the primary controller that controls the S8300
CAUTION:
LSP that you are installing. The primary controller can be an S8500 or S8700
media server. Do not administer the S8300 LSP. Translations are automatically
copied to the LSP from the primary controller.
Skip this section and go to
primary controller is an S8300.
Note:
Some of the procedures in this section may have been completed previously as
Note:
part of a normal media server installation.
This document covers only the administration of Communication Manager required for the
G700 media gateway to communicate with the primary controller over a customer's network.
For the majority of required administration, see Administrator Guide to Avaya Communication
Manager, 03-300509, or Administration for Network Connectivity for Avaya Communication
Manager, 555-233-504.
In this section, you will use the SAT interface on the primary controller to:
Assigning Node Names and IP Addresses for the C-LANs and LSPs
●
Administering Network Regions
●
Assigning LSPs to the Network Regions
●
Administering IP Interfaces
●
Administering the LSP Form
●
Note:
For information on installing the CLAN boards on the S8500 or S8700 port
Note:
networks and complete information on installing an S8700 media server, see the
Installation documentation on the Documentation for Avaya Communication
Manager, Media Gateways and Servers CD, 03-300151.
166 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
Administering an S8300 primary controller
on page 160 if the