Administering The Lsp Form - Avaya g700 Installation And Upgrades

2. Complete the fields as described the in
Table 30: IP interfaces field descriptions
Field
Type
Slot
Code/Suffix
Node name
IP Address
Subnet Mask
Gateway
Address
Enable Ethernet
Port?
Network Region
VLAN
Number of CLAN
Sockets Before
Warning
3. Close the screen.

Administering the LSP Form

If the primary server has LSPs, you must enter the LSP node names on the LSP form to enable
the LSPs to get translations updates from the primary controller. Once the LSPs are
successfully entered on the LSP form, their status can be viewed with the display lsp
command.
Table 30.
Conditions/Comments
Either C-LAN.
The slot location for the circuit pack.
Display only. This field is automatically populated with
TN799 for C-LAN.
The unique node name for the IP interface. The node
name here must already be administered on the Node
Names screen.
The IP address (on the customer LAN) of the C-LAN.
The subnet mask associated with the IP address for this
IP interface.
For more information on IP addresses and subnetting,
see "Administration for Network Connectivity for Avaya
Communication Manager, 555-233-504".
The address of a network node that serves as the default
gateway for the IP interface.
The Ethernet port must be enabled (y) before it can be
used. The port must be disabled (n) before changes can
be made to its attributes on this screen.
The region number for this IP interface.
The VLAN number assigned to the C-LAN, if any.
The threshold for the number of sockets used by this
C-LAN that triggers a warning message to be sent to the
error log.
Administer Communication Manager
Issue 8.1 June 2005 505