Avaya g700 Installation And Upgrades page 239

2. Type cd /var/home/ftp and press Enter to access the ftp directory.
3. At the prompt, type ls -ltr and press Enter to list files in the ftp directory.
The S8300 displays a list of files in the ftp directory.
4. Verify that the directory contains the *.tar.gz file you have uploaded.
5. Type sudo patch_install patch.tar.gz and press Enter.
where patch is the release or issue number of the service pack file. (For example,
03.0.526.5-1003.tar.gz).
6. Type patch_show and press Enter to list Communication Manager files to verify the new
software file was installed.
7. Type sudo patch_apply patch and press Enter.
where patch is the release or issue number of the service pack file. (For example,
03.0.526.5-1003. Do not use the *.tar.gz extension at the end of the file name).
The media server goes through a software reset system 4. You must wait until the
restart/reset has completed before entering additional commands. The reset should take
1–2 minutes (or longer if messaging is enabled).
8. Type patch_show again and press Enter to list Communication Manager files to verify the
new software file was applied.
9. Before proceeding, type statapp -c to view the status of the processes.
Make sure everything except dupmgr shows UP. Communication Manger should show
65/65 UP or, if IA770 is installed, 67/67 UP. To stop the continual refresh of the
statapp command, type Ctrl-C.
Note:
The number of processes (65/65) may vary depending on the configuration. For a
Note:
normal state, the second number should not be greater than the first number. For
example, the numbers 64/65 UP would indicate that a process did not come up
and should be investigated before proceeding.
10. Close the telnet session.
To install the pre-upgrade service pack when the current release is 2.x.
Note:
Use a telnet session to install and activate the service pack file.
Note:
The following steps activate the service pack.
1. Click Start > Run to open the Run dialog box.
2. Type telnet 192.11.13.6 and press Enter.
3. Log in as either craft or dadmin.
4. Type update_unpack and press Enter.
Upgrading the S8300A
Issue 8.1 June 2005 239