Ford 2003 Mustang Workshop Manual page 553

SECTION 206-03: Front Disc Brake
REMOVAL AND INSTALLATION
Brake Pads —Cobra
Removal
1. Remove brake fluid in the master cylinder reservoir until the reservoir is half full.
2. Raise and support the vehicle. For additional information, refer to
3. Remove the tire and wheel assembly. For additional information, refer to
4. CAUTION: Install new pads if worn to or past the specified thickness above the
metal backing plate or rivets. Install new pads in complete axle sets.
Inspect the pads for wear and contamination.
5. Remove the caliper locating pin E-clip.
6. Remove the caliper locating pin.
2003 Mustang Workshop Manual
Section 100-02 .
Section 204-04 .