Ford 2003 Mustang Workshop Manual page 321

5. CAUTION: Do not under any circumstance loosen the nut to reduce preload. If it is
necessary to reduce preload, install a new collapsible spacer (4662) and nut.
CAUTION: Remove the special tool while taking preload readings with the Nm
(inch/pound) torque wrench.
Tighten the nut to set the preload.
Rotate the drive pinion occasionally to make sure the differential pinion bearings (4630)
(4621) seat correctly. Take frequent differential pinion bearing torque preload readings by
rotating the drive pinion with a Nm (inch/pound) torque wrench.
If the preload recorded prior to disassembly is lower than the specification for used
bearings, then tighten the nut to specification. If the preload recorded prior to
disassembly is higher than the specification for used bearings, then tighten the nut to the
original reading as recorded.
Refer to the torque specification for used differential pinion bearings in the Specifications
portion of this section.
6. CAUTION: Align the index marks.
CAUTION: Install the driveshaft with new bolts. If new bolts are not available, apply
Threadlock and Sealer EOAZ-19554-AA or equivalent meeting Ford specification WSK-
M2G351-A5 to the threads of the original bolts.
CAUTION: The driveshaft centering socket yoke fits tightly on the pinion flange
pilot. To make sure that the yoke seats squarely on the flange, tighten the bolts evenly in
a cross pattern as shown.
Connect the driveshaft. For additional information, refer to Section 205-01 .