Ford 2003 Mustang Workshop Manual page 496

Item Part Number
1 4B422
2 2C189
3 —
4 4B478
5 —
6 4B478
7 4B478
8 —
9 4B478
10 2217
11 4B402
Halfshaft Handling
CAUTION: Never pick up or hold the halfshaft by the outboard joint.
Handle all halfshaft components carefully during removal and installation.
Do not over-angle the CV joints.
Damage will occur to an assembled inboard CV joint if it is over-plunged outward from the joint
housing.
Never use a hammer to remove or install the halfshafts.
Never use the halfshaft assembly as a lever to position other components. Always support the
free end of the halfshaft.
Do not allow the boots to contact sharp edges or hot exhaust components.
Description
Driveshaft bearing retainer circlip
Rear brake anti-lock sensor indicator
Retaining ring (part of 4B402)
Boot clamp (large inboard)
Rear axle shaft inner boot (part of 4B402)
Boot clamp (small inboard)
Boot clamp (small outboard)
Rear axle shaft outer boot (part of 4B402)
Boot clamp (large outboard)
Dust seal assembly
Halfshaft assembly