Ford 2003 Mustang Workshop Manual page 295

SECTION 205-01: Driveshaft
REMOVAL AND INSTALLATION
Driveshaft —Cobra
Material
Item
Threadlock® and Sealer
E0AZ-19554-AA
Silicone Lubricant
(Aerosol)
F5AZ-19553-AA
Removal and Installation
1. Raise and support the vehicle. For additional information, refer to
2. NOTE: To aid disassembly and assembly, lubricate the exhaust hangers with silicone lubricant.
Remove the two exhaust hangers from the rubber mounts.
3. Remove the nuts on the left side exhaust.
4. Lower the muffler pipe enough to clear the flange. Move the muffler assembly forward to
disconnect the third exhaust hanger.
5. Carry out the following:
1. Place an index mark on the rear axle pinion flange and the driveshaft centering socket
yoke.
Specification
WSK-M2G351-A5 (type
II)
ESR-M13P4-A
2003 Mustang Workshop Manual
Section 100-02 .