Ford 2003 Mustang Workshop Manual page 302

SECTION 205-01: Driveshaft
DISASSEMBLY AND ASSEMBLY
Universal Joint —Single Cardan, Flange Yoke
Special Tool(s)
Installer/Remover, C Frame
and Screw
205-086 (T74P-4635-C)
Disassembly
1. Remove the driveshaft (4602). For additional information, refer to
2. CAUTION: Under no circumstances is the driveshaft assembly to be clamped in the
jaws of a vise or similar holding fixture. Denting or localizing fracture can result, causing
driveshaft failure during vehicle operation.
Place the driveshaft on a suitable workbench, being careful not to damage the tube.
3. NOTE: If components are not marked and installed correctly, driveline imbalance can occur.
Index-mark the positions of the driveshaft components.
4. Clamp the U-joint tool in a vise.
5. Remove all four of the snap rings.
2003 Mustang Workshop Manual
Driveshaft in this section.