Ford 2003 Mustang Workshop Manual page 704

SECTION 206-09B: Anti-Lock Control — Traction Control
REMOVAL AND INSTALLATION
Module
Removal
1. Remove the hydraulic control unit (HCU). Refer to
2. Remove the pump motor electrical connector.
3. Remove the anti-lock-brake control module screws.
4. Remove the anti-lock-brake control module from the HCU.
Installation
1. NOTE: The brake system must be bled after the HCU is installed or replaced. Refer to
206-00 .
To install, reverse the removal procedure.
2003 Mustang Workshop Manual
Hydraulic Control Unit .
Section