Ford 2003 Mustang Workshop Manual page 438

SECTION 205-02C: Rear Drive Axle/Differential — Ford 8.8-Inch IRS
IN-VEHICLE REPAIR
Drive Pinion Flange
Special Tool(s)
2-Jaw Puller
205-D072 (D97L-4221-A) or
equivalent
Holding Fixture, Drive Pinion
Flange
205-126 (T78P-4851-A)
Installer, Drive Pinion Flange
205-002 (TOOL-4858-E) or
equivalent
Removal
1. Raise and support the vehicle. For additional information, refer to
2. Remove the rear wheel and tire assemblies. For additional information, refer to
3. CAUTION: Remove the rear brake calipers to prevent drag during the drive pinion
bearing preload adjustment.
CAUTION: Do not allow the calipers to hang from the brake hoses.
Remove the rear brake caliper and support bracket from the knuckle as an assembly. Wire the
caliper and support bracket assembly out of the way. For additional information, refer to
206-04 .
4. CAUTION: Index-mark the driveshaft flange and rear axle pinion flange (4851) to
maintain initial balance during installation.
CAUTION: The driveshaft centering socket yoke fits tightly on the rear axle pinion
flange pilot. Never hammer on the driveshaft (4602) or any of its components to
disconnect the yoke from the flange. Pry only in the area shown, with a suitable tool, to
disconnect the yoke from the flange.
Disconnect and position the driveshaft out of the way. For additional information, refer to
Section 205-01 .
2003 Mustang Workshop Manual
Section 100-02 .
Section 204-04 .
Section