Ford 2003 Mustang Workshop Manual page 532

Hide thumbs Also See for 2003 Mustang:

Table of Contents

5. Repeat Steps 2, 3 and 4 for the LH rear bleeder screw, the RH front disc brake caliper (2B120)

bleeder screw, and the LH front disc brake caliper bleeder screw, in that order.

6. Connect the scan tool DCL cable adapter into the vehicle data link connector (DLC) under the

dash, and follow the scan tool instructions.

7. Repeat the system bleed procedure as outlined in Steps 1 through 5.

1. NOTE: It is not necessary to do a complete brake system bleed if only the disc brake caliper

(2B120) was disconnected.

Place a box end wrench on the disc brake caliper bleeder screw (2208). Attach a rubber drain

tube to the disc brake caliper bleeder screw, and submerge the free end of the tube in a

container partially filled with clean brake fluid.

Show Quick Links

Table of Contents