2. Raise and support the vehicle. For additional information, refer to
3. Remove the rear wheel and tire assemblies. For additional information, refer to
4. Remove the exhaust system. For additional information, refer to
5. Remove the pinion nose crossmember.
6.
CAUTION: Index-mark the driveshaft flange and rear axle pinion flange (4851) to
maintain initial balance during installation.
CAUTION: The driveshaft centering socket yoke fits tightly on the rear axle pinion
flange pilot. Never hammer on the driveshaft (4602) or any of its components to
disconnect the yoke from the flange. Pry only in the area shown, with a suitable tool, to
disconnect the yoke from the flange.
Disconnect and position the driveshaft out of the way.
7. NOTE: The following halfshaft and knuckle assembly removal steps apply to both sides of the
vehicle.
Section 100-02
.
Section 204-04
Section 309-00
.
.