Ford 2003 Mustang Workshop Manual page 190

Step Plate Adapter Set
205-DS011 (D80L-630-A) or
Equivalent
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital
components and systems and their failure can result in major service expense. A new part with
the same part number must be installed if installation becomes necessary. If substitution is
necessary, the part must be of the same finish and property class. Torque values must be used
as specified during reassembly to make sure of correct retention of these parts.
1. Remove the rear wheel knuckle (5A968/5A969). For additional information, refer to
Knuckle—Cobra
2. Remove the bolts and the dust shield. Discard the bolts.
3. Position the knuckle in a vise.
4. NOTE: There are two methods for removing the rear hub (1109) from the rear wheel bearing
(1A049). Both methods are shown.
Method one. Using the special tools, remove the hub.
in this section.
Wheel