Ford 2003 Mustang Workshop Manual page 1020

10. Remove the three exhaust manifold studs.
11. NOTE: Discard the cylinder head gasket.
NOTE: Record the location of the long bolts and the short bolts.
Remove the cylinder head. Discard the cylinder head bolts.
Installation
NOTE: Do not use a fiber disc to clean the surfaces. Fibers from the disc can get into the oil pan and
oil and clog the oil bypass valve.
1. Clean and inspect the cylinder head for flatness. For additional information, refer to
303-00 .
2. Install a new head gasket on the cylinder block with the small hole to the front of the engine and
position the cylinder head.
Section