Ford 2003 Mustang Workshop Manual page 513

SECTION 206-00: Brake System — General Information
DIAGNOSIS AND TESTING
Brake System
Refer to Wiring Diagrams Cell
Refer to Wiring Diagrams Cell
Special Tool(s)
73 Digital Multimeter
105-R0051 or Equivalent
ABS Brake and Pressure Test
Kit
107-02350 or Equivalent
Tire and Wheel Runout Gauge
Set
134-00199 or Equivalent
Inspection and Verification
WARNING: Use of any other than the approved DOT 3 brake fluid will cause permanent
damage to brake components and will render the brakes inoperative.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with
eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with
running water for 15 minutes. Get medical attention if irritation persists. If taken internally,
drink water and induce vomiting. Get medical attention immediately.
CAUTION: Do not spill brake fluid onto painted surfaces. If spilled, wipe up immediately.
NOTE: Always check the fluid level in the brake master cylinder reservoir (2K478) before performing
the test procedures. If the fluid level is not at the correct level, add High Performance DOT 3 Brake
Fluid C6AZ-19542-AB or equivalent DOT 3 fluid meeting Ford specification ESA-M6C25-A.
NOTE: Prior to performing any diagnosis, make sure the brake warning indicator is functional. For
additional information, refer to
The first indication that something may be wrong in the brake system is a change in the feeling through
the brake pedal (2455). The brake warning indicator in the instrument cluster and the brake fluid level
60 , Instrument Cluster for schematic and connector information.
97 , Daytime Running Lamps for schematic and connector information.
Section 413-01 .
2003 Mustang Workshop Manual