Ford 2003 Mustang Workshop Manual page 318

SECTION 205-02A: Rear Drive Axle/Differential — Ford 7.5-Inch Ring
Gear
IN-VEHICLE REPAIR
Drive Pinion Flange and Drive Pinion Seal
Special Tool(s)
2-Jaw Puller
205-D072 (D97L-4221-A) or
equivalent
Holding Fixture, Drive Pinion
Flange
205-126 (T78P-4851-A)
Installer, Drive Pinion Flange
205-002 (TOOL-4858-E) or
equivalent
Removal
1. Raise and support the vehicle. For additional information, refer to
2. Remove the rear wheel and tire assemblies. For additional information, refer to
3. CAUTION: Remove the rear brake calipers to prevent drag during the drive pinion
bearing preload adjustment.
CAUTION: Do not allow the calipers to hang from the brake hoses.
Remove the rear brake caliper and support bracket from the knuckle as an assembly. Wire the
caliper and support bracket assembly out of the way. For additional information, refer to
206-04 .
4. CAUTION: Index-mark the driveshaft flange and pinion flange (4851) to maintain
initial balance during installation.
CAUTION: The driveshaft centering socket yoke fits tightly on the pinion flange
pilot. Never hammer on the driveshaft or any of its components to disconnect the yoke
from the flange. Pry only in the area shown, with a suitable tool, to disconnect the yoke
from the flange.
Disconnect and position the driveshaft out of the way. For additional information, refer to
2003 Mustang Workshop
Manual
Section 100-02 .
Section 204-04 .
Section