Ford 2003 Mustang Workshop Manual page 201

SECTION 204-02: Rear Suspension
REMOVAL AND INSTALLATION
Upper Arm —Cobra
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital
components and systems and their failure can result in major service expense. A new part with
the same part number must be installed if installation becomes necessary. If substitution is
necessary, the part must be of the same finish and property class. Torque values must be used
as specified during reassembly to make sure of correct retention of these parts.
1. Mark the rear shock absorber (18125) relative to the protective sleeve with the vehicle in a
static, level ground position (curb height).
2. Raise the vehicle on a hoist. For additional information, refer to
3. Remove both wheel and tire assemblies. For additional information, refer to
4. Remove the rear brake disc. For additional information, refer to
5. Remove the rear springs (5560). For additional information, refer to
section.
6. Raise the subframe into position and remove the front bolts.
7. Lower the subframe from the vehicle.
8. Mark the cam bolt position relative to the upper suspension arm and bushing (5500).
2003 Mustang Workshop Manual
Section 100-02 .
Section 204-04
Section 206-04 .
Spring—Cobra
.
in this