Ford 2003 Mustang Workshop Manual page 118

SECTION 100-04: Noise, Vibration and Harshness
GENERAL PROCEDURES
Brake Disc Machining
Special Tool(s)
Gauge, Clutch Housing
308-021 (T75L-4201-A)
Dial Indicator Gauge with
Holding Fixture
100-002 (TOOL-4201-C) or
equivalent
Material
Item
Metal Surface Cleaner
F4AZ-19A536-RA or equivalent
High Temperature Nickel Anti-
Seize Lubricant
F6AZ-9L494-AA or equivalent
WARNING: The electrical power to the air suspension system must be shut off prior to
hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off
the air suspension switch. Failure to do so can result in unexpected inflation or deflation of the
air springs, which can result in shifting of the vehicle during these operations.
CAUTION: Do not install brake discs that are less than the minimum thickness specified.
Do not machine a brake disc below the minimum thickness specification.
1. Check wheel bearing end-play and correct as necessary.
2. NOTE: Begin at the front of the vehicle unless the vibration has been isolated to the rear.
Remove the tire and wheel assembly.
3. Remove the brake caliper and the brake caliper anchor plate. Refer to the appropriate section in
Group 206 for the procedure.
4. Inspect the brake linings. Install new brake linings if below specification. For additional
information, refer to the appropriate brake section.
5. Measure and record the brake disc thickness. Install a new brake disc if the thickness after
machining will be at or below specification. The specification is molded into the brake disc.
Do not machine a new brake disc.
Specification
WSE-M5B392-
A
ESE-M12A4-A
2003 Mustang Workshop Manual