Ford 2003 Mustang Workshop Manual page 408

SECTION 205-02B: Rear Drive Axle/Differential — Ford 8.8-Inch Ring
Gear
REMOVAL AND INSTALLATION
Axle Housing
Removal and Installation
1. CAUTION: The vehicle must be on level ground and at curb height.
Mark the rear shock absorbers relative to their protective sleeve.
During installation, raise the suspension to this reference mark before tightening the
suspension fasteners.
2. Raise and support the vehicle. For additional information, refer to
3. Remove the rear wheel and tire assemblies. For additional information, refer to
4. NOTE: If necessary, use Rust Penetrant and Inhibitor F2AZ-19A501-A meeting Ford
specification ESR-M99C56-A to loosen the sensor for removal.
Remove the rear anti-lock brake sensors from the rear disc brake adapters. For additional
information, refer to
5. Disconnect the parking brake cables and conduits from the rear disc brake calipers. For
additional information, refer to
Section 206-09A .
Section 206-05
2003 Mustang Workshop
Section 100-02
.
Manual
.
Section 204-04 .