Ford 2003 Mustang Workshop Manual page 220

17. Remove the dust shield, hub, snap ring and bearing from the knuckle. For additional
information, refer to
Installation
1. Install the bearing, snap ring, hub and dust shield. For additional information, refer to
Hub—Cobra in this section.
2. Install the knuckle.
1. Position the knuckle on the lower suspension arm and bushing.
2. Install a new bolt and a new nut. Do not tighten the nut at this time.
3. Connect the axle shaft to the hub.
1. Making sure the splines on the shaft line up with the splines in the hub, install the axle
shaft into the hub.
2. Install a new retainer. Do not tighten the retainer at this time.
4. Connect the upper suspension arm and bushing to the knuckle.
1. Position the upper suspension arm and bushing on the knuckle.
2. Install a new cam bolt and a new nut. Do not tighten the nut at this time.
Wheel Hub—Cobra in this section.
Wheel