SECTION 303-00: Engine System — General Information
GENERAL PROCEDURES
Crankshaft End Play
Special Tool(s)
Dial Indicator Gauge with
Holding Fixture
100-002 (TOOL-4201-C) or
equivalent
1. Measure the crankshaft end play. Use a Dial Indicator Gauge with Holding Fixture to measure
crankshaft end play.
2. Position the crankshaft to the rear of the cylinder block.
3. Zero the indicator.
4. Move the crankshaft to the front of the cylinder block. Note and record the crankshaft end play.
If crankshaft end play exceeds specifications, install a new crankshaft thrust washer
(6334) or crankshaft thrust main bearing (6337). Refer to the appropriate section in
Group
303
for the procedure.
2003 Mustang Workshop Manual