Ford 2003 Mustang Workshop Manual page 216

SECTION 204-02: Rear Suspension
REMOVAL AND INSTALLATION
Wheel Knuckle —Cobra
Special Tool(s)
Front Hub Remover
205-D070 (D93P-1175-B) or
Equivalent
Steering Arm Remover
211-003 (T64P-9171-A)
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital
components and systems and their failure can result in major service expense. A new part with
the same part number must be installed if installation becomes necessary. If substitution is
necessary, the part must be of the same finish and property class. Torque values must be used
as specified during reassembly to make sure of correct retention of these parts.
1. Mark the rear shock absorber (18125) relative to the protective sleeve with the vehicle in a
static, level ground position (curb height).
2. Raise the vehicle on a hoist. For additional information, refer to
3. Remove the wheel and tire assembly. For additional information, refer to
4. Remove and discard the rear hub retainer (4B477).
2003 Mustang Workshop Manual
Section 100-02 .
Section 204-04 .