Ford 2003 Mustang Workshop Manual page 540

7. If the total indicated runout exceeds the maximum specification, remove the brake disc. For
additional information, refer to
8. Clean the brake disc mounting face of dirt, rust and foreign material.
9. For front wheels, measure and record the total indicated runout of the hub face outside the stud
circle.
10. Install a new front hub if the total indicated runout exceeds the maximum specification. For
additional information, refer to
Repeat the hub runout measurement.
11. NOTE: Clean the axle flange surface before measuring.
NOTE: For rear wheels, press inward on the axle shaft while measuring the rear axle runout.
For rear wheels, measure and record the total indicated runout at a point on the axle shaft
outside the stud circle.
12. If the total indicated runout exceeds the maximum specification, inspect the rear axle. For
additional information, refer to
Repeat the rear brake disc runout measurement.
Section 206-03 for front or to
Section 204-01 .
Section 205-00 . Repair as necessary.
Section 206-04 for rear.