Ford 2003 Mustang Workshop Manual page 436

5. Lubricate the lip of the new inboard CV joint stub shaft pilot bearing housing seal.
Use Premium Long-Life Grease XG-1-C or equivalent meeting Ford specification ESA-
M1C75-B.
6. CAUTION: Installation without the correct tools can result in early seal failure.
Place the inboard CV joint stub shaft pilot bearing housing seal onto the special tools.
7. CAUTION: If the inboard CV joint stub shaft pilot bearing housing seal becomes
misaligned in the bore during installation, remove it and install a new one.
Carefully align the inboard CV joint stub shaft pilot bearing housing seal in the housing bore and
install the seal.
8. CAUTION: Use special tool 205-461 to avoid damaging the new inboard CV joint
stub shaft pilot bearing housing seal when installing the halfshaft.
Install the halfshaft.
If the knuckle and halfshaft were removed as an assembly, refer to
section. If the halfshaft was removed from the knuckle, refer to
Axle Housing in this
Section 205-05 .