Ford 2003 Mustang Workshop Manual page 167

SECTION 204-01: Front Suspension
REMOVAL AND INSTALLATION
Spindle
Special Tool(s)
Tie-Rod End Remover
211-001 (TOOL-3290-D) or
Equivalent
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital
components and systems and their failure can result in major service expense. A new part with
the same part number or an equivalent part must be installed, if installation is necessary. Do
not use a part of lesser quality or substitute design. Torque values must be used as specified
during reassembly to ensure correct retention of these parts.
1. Raise the vehicle on a hoist. For additional information, refer to
2. Remove the wheel and tire assembly. For additional information, refer to
3. Remove the front wheel hub (1104). For additional information, refer to
in this section.
4. Remove the bolt and the ABS sensor.
5. Unclip the ABS sensor wire from the bracket.
2003 Mustang Workshop Manual
Section 100-02 .
Section 204-04
Wheel Hub and Bearing
.