Ford 2003 Mustang Workshop Manual page 60

Air leak at outer
belt line
Draft at inner
door
handle/speaker
opening
Wind noise from
side view mirror
Air leak around
perimeter of fixed
No contact with side
glass.
No contact with glass
runs at both ends of
belt line seal.
Belt line seal damaged.
Belt line seal installed
incorrectly on flange
(no glass contact).
Belt line seal does not
contact the glass.
No contact with glass
runs at both ends of
belt line seal.
Belt line seal damaged.
Hole in watershield.
Watershield
misaligned.
Exterior door handle
seal
misaligned/damaged.
Outside mirror housing
misaligned.
Mirror sail gasket
folded/misaligned.
Mirror housing trim cap
installed incorrectly.
Air leak through mirror
housing hinge.
Inner sail trim installed
incorrectly.
Inner sail gasket/barrier
installed incorrectly.
Air path through wiring
bundle/fastener access
holes.
Exposed fastener
access hole on mirror
housing/sail.
Gaps in the sealant
bead.
ADJUST the door glass.
ADJUST the belt line seal
or ADD foam at the seal
ends.
INSTALL a new seal.
ADJUST the seal.
ADJUST the door glass.
ADJUST the belt line
seal/ADD foam at the seal
ends.
INSTALL a new seal.
SEAL the hole with a
suitable tape.
REALIGN the watershield.
INSTALL a new
watershield if the pressure
sensitive adhesive fails.
REALIGN or INSTALL a
new seal as necessary.
REALIGN with the edges
shingled correctly and no
gaps.
REINSTALL with the
gasket unfolded and
aligned correctly.
REINSTALL with the
edges shingled to the air
flow.
Fully ENGAGE the mirror
into its operating
position/USE foam to
block the air path through
the hinge.
REINSTALL the sail
trim/ADJUST the door
trim.
REINSTALL the trim
cover with the
gasket/barrier aligned
correctly.
BLOCK the air path(s)
with foam/tape.
INSTALL a new cap if it is
missing.
APPLY approved sealant.